# Taper control

**URL:** <https://titansforum.titansofcnc.com/t/taper-control/6728>\
**Category:** Site Feedback\
**Created:** [February 26, 2019, 1:02am UTC](https://titansforum.titansofcnc.com/t/taper-control/6728 "2019-02-26T01:02:14Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![FrankGarza](https://avatars.discourse-cdn.com/v4/letter/f/f07891/32.png) [@FrankGarza](https://titansforum.titansofcnc.com/u/FrankGarza)\
**Post date:** [February 26, 2019, 1:02am UTC](https://titansforum.titansofcnc.com/t/taper-control/6728/1 "2019-02-26T01:02:14Z")

</div>

I use to run a CNC lathe/ Daewoo Puma with fanuc controls and there was a code for taper control I forgot what it was! does anyone know what it is?

---

<div class="post-metadata">

**Author:** ![MikeJones86](https://yyz1.discourse-cdn.com/flex035/user_avatar/titansforum.titansofcnc.com/mikejones86/32/511_2.png) [@MikeJones86](https://titansforum.titansofcnc.com/u/MikeJones86)\
**Post date:** [February 26, 2019, 3:36am UTC](https://titansforum.titansofcnc.com/t/taper-control/6728/2 "2019-02-26T03:36:30Z")

</div>

This should help been a while since I have been on a lathe.

[http://www.helmancnc.com/taper-turning-with-g90-modal-turning-cycle-cnc-example-code/](http://www.helmancnc.com/taper-turning-with-g90-modal-turning-cycle-cnc-example-code/)

---

<div class="post-metadata">

**Author:** ![FrankGarza](https://avatars.discourse-cdn.com/v4/letter/f/f07891/32.png) [@FrankGarza](https://titansforum.titansofcnc.com/u/FrankGarza)\
**Post date:** [February 26, 2019, 4:02am UTC](https://titansforum.titansofcnc.com/t/taper-control/6728/3 "2019-02-26T04:02:34Z")

</div>

thanks mike but I’m not turning a tapered finish I’m turning a shaft in between a live center so your x will have a taper